# Why use 24v power for vibration, why we keep always-10 voltage for adjustment of vibration?

**URL:** <https://forumautomation.com/t/why-use-24v-power-for-vibration-why-we-keep-always-10-voltage-for-adjustment-of-vibration/8922>\
**Category:** Field Instrumentation\
**Created:** [December 7, 2020, 5:23am UTC](https://forumautomation.com/t/why-use-24v-power-for-vibration-why-we-keep-always-10-voltage-for-adjustment-of-vibration/8922 "2020-12-07T05:23:05Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![instrumentationtechi](https://forumautomation.com/letter_avatar_proxy/v4/letter/i/50afbb/32.png) [@instrumentationtechi](https://forumautomation.com/u/instrumentationtechi)\
**Post date:** [December 7, 2020, 5:23am UTC](https://forumautomation.com/t/why-use-24v-power-for-vibration-why-we-keep-always-10-voltage-for-adjustment-of-vibration/8922/1 "2020-12-07T05:23:05Z")

</div>

IS 24V compulsory for vibration

---

<div class="post-metadata">

**Author:** ![ashlin](https://forumautomation.com/user_avatar/forumautomation.com/ashlin/32/3775_2.png) [@ashlin](https://forumautomation.com/u/ashlin)\
**Post date:** [December 7, 2020, 5:28am UTC](https://forumautomation.com/t/why-use-24v-power-for-vibration-why-we-keep-always-10-voltage-for-adjustment-of-vibration/8922/2 "2020-12-07T05:28:49Z")

</div>

The output is 0to 24v depending on the gap For most probes, the power needed for it to work is from 20v to 24 v That 10 v depends on what’s your plant spec for instance the gap that we keep on a turbine when doing center lining its - 11.5v. We will not keep always -10.so according to Design it will vary.
