# When to use PD control system?

**URL:** <https://forumautomation.com/t/when-to-use-pd-control-system/1109>\
**Category:** Industrial Automation\
**Created:** [June 26, 2016, 7:55pm UTC](https://forumautomation.com/t/when-to-use-pd-control-system/1109 "2016-06-26T19:55:04Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![automate](https://forumautomation.com/letter_avatar_proxy/v4/letter/a/51bf81/32.png) [@automate](https://forumautomation.com/u/automate)\
**Post date:** [June 26, 2016, 7:55pm UTC](https://forumautomation.com/t/when-to-use-pd-control-system/1109/1 "2016-06-26T19:55:05Z")

</div>

The general rule for probably 80 to 90% of the control loops is that P and I action is good enough. Here, during a Setpoint change, P gives you the necessary initial kick while I brings you in to Setpoint through a smooth landing.

So the question is where and how to use D. This can be coupled with when and how to use different forms of the PID equation. Knowing these 2 pieces of information (among others) helps you grasp issues such as slow time to stability or poor response during disturbances,

First D, understand that its a “Derivative” aka a rate of change of PV over time implying the higher the rate of change of PV, the greater the D impact on the Output. As a result, it acts well to prevent PV overshoot or to help kick a slow process.

PD Controller use only when we want very fast action SP=PV…but we cant get bump less action in control valve.

PD control, is under certain conditions a very acceptable solution. It provides rapid response with little or no overshoot. Typically used on large non-symmetrical Integrating processes such as furnaces, space heating etc. There will be inherent offset but that is not always an issue

---

<div class="post-metadata">

**Author:** ![angcheebeng](https://forumautomation.com/letter_avatar_proxy/v4/letter/a/f04885/32.png) [@angcheebeng](https://forumautomation.com/u/angcheebeng)\
**Post date:** [July 3, 2016, 1:34pm UTC](https://forumautomation.com/t/when-to-use-pd-control-system/1109/2 "2016-07-03T13:34:26Z")

</div>

I love the way you explain it.

To share more information about PID with fellow members, I recommend an article here [PID Motion Control for Beginners](http://motka.com.sg/media/newsletters/NewsletterJune2016.html) Hope it helps someone.
