# What is the reason for control valve passing

**URL:** <https://forumautomation.com/t/what-is-the-reason-for-control-valve-passing/9331>\
**Category:** Field Instrumentation\
**Created:** [April 16, 2021, 7:44am UTC](https://forumautomation.com/t/what-is-the-reason-for-control-valve-passing/9331 "2021-04-16T07:44:40Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![instrumentationtechi](https://forumautomation.com/letter_avatar_proxy/v4/letter/i/50afbb/32.png) [@instrumentationtechi](https://forumautomation.com/u/instrumentationtechi)\
**Post date:** [April 16, 2021, 7:44am UTC](https://forumautomation.com/t/what-is-the-reason-for-control-valve-passing/9331/1 "2021-04-16T07:44:40Z")

</div>

What could be the probable causes of the control valve passing

---

<div class="post-metadata">

**Author:** ![ashlin](https://forumautomation.com/user_avatar/forumautomation.com/ashlin/32/3775_2.png) [@ashlin](https://forumautomation.com/u/ashlin)\
**Post date:** [April 16, 2021, 7:47am UTC](https://forumautomation.com/t/what-is-the-reason-for-control-valve-passing/9331/2 "2021-04-16T07:47:24Z")

</div>

It could be because of many reasons

Bench Set is set too low.

The valve Plug is not seated.

Plug or Seat is washed out.

The body is washed out.

The air signal to the Actuator is incorrect.

The bench set is not proper

Calibration not proper

Disc damage

Plug scratch

Dust particulars in the body
