# What are the primary steps involved in creating a project with Node-RED and a PLC?

**URL:** <https://forumautomation.com/t/what-are-the-primary-steps-involved-in-creating-a-project-with-node-red-and-a-plc/12019>\
**Category:** PLC (Programmable Logic Controllers)\
**Tags:** plc\
**Created:** [April 29, 2024, 2:17pm UTC](https://forumautomation.com/t/what-are-the-primary-steps-involved-in-creating-a-project-with-node-red-and-a-plc/12019 "2024-04-29T14:17:11Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![Rabert](https://forumautomation.com/user_avatar/forumautomation.com/rabert/32/6784_2.png) [@Rabert](https://forumautomation.com/u/Rabert)\
**Post date:** [April 29, 2024, 2:17pm UTC](https://forumautomation.com/t/what-are-the-primary-steps-involved-in-creating-a-project-with-node-red-and-a-plc/12019/1 "2024-04-29T14:17:11Z")

</div>

Creating a project using Node-RED and a PLC requires multiple steps.

 ![7](https://cdn.forumautomation.com/original/2X/4/409681a4ccd652914639fca626dbdec617e95216.jpeg)

Here is the step-by-step procedure:

**Step-1.** Choose a PLC that works with Node-RED. Omron, Mitsubishi, & Schneider Electric are some of the notable PLC types that support Node-RED.

**Step-2.** Install Node-RED on your computer. You may get the most recent edition of Node-RED from the official website.

**Step-3.** Download and install the PLC driver for the PLC brand you’ve chosen. This enables Node-RED to communicate with the PLC.

**Step-4.** Create a new Node-RED project: Open the Node-RED software and start a new Node-RED project.

**Step-5.** Add the PLC node to the project you are working on. This node enables you to communicate with the PLC.

**Step-6.** Configure the PLC node: Configure the PLC node by entering the PLC’s IP address or serial port, as well as any other PLC-specific information.

**Step-7.** Add additional nodes: Add additional nodes to your project whenever necessary to control and read data from the PLC. Some common nodes for dealing with PLCs are:

- Input nodes: These nodes let you read data from the PLC’s input points.
- The PLC has two types of nodes: output nodes for writing data and analogue input nodes for reading data.
- Analogue output nodes: These nodes enable you to send analogue data to the PLC’s analogue output ports.

**Step-8.** Wire the nodes: Connect the nodes to form a flow that reads data from the PLC, processes it, & returns the results to the PLC.

**Step-9.** Deploy the project to the PLC. This transfers the flow to the PLC, allowing it to operate independently.

**Step-10.** Test the project: Make sure the project is working properly and that the PLC responds as intended.
