# Problems related to Ethernet card

**URL:** <https://forumautomation.com/t/problems-related-to-ethernet-card/9426>\
**Category:** Field Instrumentation\
**Created:** [May 24, 2021, 4:12am UTC](https://forumautomation.com/t/problems-related-to-ethernet-card/9426 "2021-05-24T04:12:49Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![instrumentationtechi](https://forumautomation.com/letter_avatar_proxy/v4/letter/i/50afbb/32.png) [@instrumentationtechi](https://forumautomation.com/u/instrumentationtechi)\
**Post date:** [May 24, 2021, 4:12am UTC](https://forumautomation.com/t/problems-related-to-ethernet-card/9426/1 "2021-05-24T04:12:49Z")

</div>

I have power cycled a panel and it looks like the Ethernet card is now fried, it took a breaker out with it. I’ve not been able to ping the IP address although when I open cx programmer I can still go online and view the ladder etc

---

<div class="post-metadata">

**Author:** ![ashlin](https://forumautomation.com/user_avatar/forumautomation.com/ashlin/32/3775_2.png) [@ashlin](https://forumautomation.com/u/ashlin)\
**Post date:** [May 24, 2021, 4:14am UTC](https://forumautomation.com/t/problems-related-to-ethernet-card/9426/2 "2021-05-24T04:14:25Z")

</div>

If the Ethernet card had a fault it would show an error code, also when you connect to the CPU through CX-Programmer and go online there would be a fault in the error log.

Setup and connection of the EIP21 are done through Network Configurator, not CX-Programmer (Connect through the CPU backplane).

All connected devices to the EIP21 would usually go through a network switch, if you have lost comms is it the switch at fault?
