# Problems related to AVT320 drive

**URL:** <https://forumautomation.com/t/problems-related-to-avt320-drive/9884>\
**Category:** Electrical\
**Created:** [September 28, 2021, 12:36pm UTC](https://forumautomation.com/t/problems-related-to-avt320-drive/9884 "2021-09-28T12:36:04Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![instrumentationtechi](https://forumautomation.com/letter_avatar_proxy/v4/letter/i/50afbb/32.png) [@instrumentationtechi](https://forumautomation.com/u/instrumentationtechi)\
**Post date:** [September 28, 2021, 12:36pm UTC](https://forumautomation.com/t/problems-related-to-avt320-drive/9884/1 "2021-09-28T12:36:04Z")

</div>

I am using the AVT320 drive for EOT crain, so when i give +ve reference it works properly but while giving the -ve reference the motor would go +ve and after a few seconds it would go to the -ve side, what could be the problem

---

<div class="post-metadata">

**Author:** ![ashlin](https://forumautomation.com/user_avatar/forumautomation.com/ashlin/32/3775_2.png) [@ashlin](https://forumautomation.com/u/ashlin)\
**Post date:** [September 28, 2021, 12:45pm UTC](https://forumautomation.com/t/problems-related-to-avt320-drive/9884/2 "2021-09-28T12:45:48Z")

</div>

This could occur mostly in hoist drives and it’s normal, It is designed to develop a starting torque against free fall of the load when the brake is released & speed is 0. Provide breaking resistor & Set de-acceleration minimum time like 0.2 sec, not 0.0

Just check and adjust brake timing, I suggest delaying the brake release time
