# Penstock valve basics

**URL:** <https://forumautomation.com/t/penstock-valve-basics/3251>\
**Category:** Valves\
**Created:** [March 8, 2018, 6:04pm UTC](https://forumautomation.com/t/penstock-valve-basics/3251 "2018-03-08T18:04:06Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![sivaranjith](https://forumautomation.com/letter_avatar_proxy/v4/letter/s/ba9def/32.png) [@sivaranjith](https://forumautomation.com/u/sivaranjith)\
**Post date:** [March 8, 2018, 6:04pm UTC](https://forumautomation.com/t/penstock-valve-basics/3251/1 "2018-03-08T18:04:07Z")

</div>

![penstock](https://cdn.forumautomation.com/original/2X/a/af95015a94f51f2244a1620bb7fa8bde4b294872.png)

A penstock is a single-faced valve consisting of an open frame and a door. This form of valve is normally located in tanks or channels as a means of controlling flow into a pipe. There are different types of penstock available, main are:

- Penstocks for operating against pressure, i.e. pressure forcing the door onto the frame.

- Penstocks for operating against off-seating pressure, i.e. pressure forcing the door away from the frame.

- Penstocks designed to accommodate both seating and off-seating pressures.

> ## Construction:

 ![penstock](https://cdn.forumautomation.com/original/2X/e/e25d9538852cdd2f06871202ab29c85088213aef.png)

Penstock frames may be circular or rectangular. In the latter case a preferred proportion of width to depth is 2:3 for vertical form, and 4 :3 for horizontal form. Frames and gates are commonly made of cast iron, although plastic materials (usually reinforced steel) are also used for gates operating in aluminium. stainless steel or epoxy-coated frames for corrosive applications. Frames may be for channel or wall-mounted application. Sealing faces in suitable materials are embedded into both the frame and door surfaces.

 ![penstock](https://cdn.forumautomation.com/original/2X/5/52c27764083b2217a2191e9f894c74265769440e.png)

Handwheel operation of the gate is normal, using a rising stem supported by a suitable headstock or bracket. The advantage of a rising stem is that the screw thread at the bottom of the stem is not usually immersed and is readily accessible for lubrication. A non-rising stem eliminates the need for a headstock and merely rotates through a nut in the penstock door. The threaded portion at the bottom is then usually immersed in the product being handled.

 ![penstock](https://cdn.forumautomation.com/original/2X/8/890a10d8226453d0a90811d5796ffb395effbd74.png)

Seating pressure can be accommodated by the use of side wedges only. Off-seating pressure requires the use of bottom wedges or top and bottom wedges. Penstocks subject to sealing pressure normally seal tighter than penstocks for off-sealing pressure duties. Both types can be made virtually drop-tight with correct installation, distortion of the gate frame at the time of installa tion being the determining factor as far as leakage is concerned.
