# Network Storm/ Network Traffic in honeywell DCS

**URL:** <https://forumautomation.com/t/network-storm-network-traffic-in-honeywell-dcs/214>\
**Category:** Honeywell\
**Created:** [December 30, 2014, 5:28pm UTC](https://forumautomation.com/t/network-storm-network-traffic-in-honeywell-dcs/214 "2014-12-30T17:28:10Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![instrumen](https://forumautomation.com/letter_avatar_proxy/v4/letter/i/65b543/32.png) [@instrumen](https://forumautomation.com/u/instrumen)\
**Post date:** [December 30, 2014, 5:28pm UTC](https://forumautomation.com/t/network-storm-network-traffic-in-honeywell-dcs/214/1 "2014-12-30T17:28:12Z")

</div>

By definition, a “network storm” (or “data storm”) is excessive transmission of network traffic. Network storms can be experienced on FTE (Fault Tolerant Ethernet) through a variety of reasons including, but not limited to the following: • Insertion of a network loop in the CF9, which is caused by the inappropriate insertion of a network cable from one CF9 to itself, or its redundant CF9 partner. • Insertion of a (similar) network loop in a CISCO switch. • Misconfiguration of a L1 or L2 CISCO switch. This action itself does not cause a storm, but can expose the control components to network storms from other portions of the plant network. • Installation of non-qualified, third party software on Experion Servers, Flex Stations or Console Stations can cause resource leaks on the PC which can lead to network storms.
