# Is it possible to temporarily jump out a sensor by forcing an output in the PLC

**URL:** <https://forumautomation.com/t/is-it-possible-to-temporarily-jump-out-a-sensor-by-forcing-an-output-in-the-plc/9868>\
**Category:** PLC (Programmable Logic Controllers)\
**Created:** [September 21, 2021, 3:56am UTC](https://forumautomation.com/t/is-it-possible-to-temporarily-jump-out-a-sensor-by-forcing-an-output-in-the-plc/9868 "2021-09-21T03:56:07Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![instrumentationtechi](https://forumautomation.com/letter_avatar_proxy/v4/letter/i/50afbb/32.png) [@instrumentationtechi](https://forumautomation.com/u/instrumentationtechi)\
**Post date:** [September 21, 2021, 3:56am UTC](https://forumautomation.com/t/is-it-possible-to-temporarily-jump-out-a-sensor-by-forcing-an-output-in-the-plc/9868/1 "2021-09-21T03:56:07Z")

</div>

Would you force an output in the PLC, or use a physical jumper wire to temporarily jump out a sensor

---

<div class="post-metadata">

**Author:** ![ashlin](https://forumautomation.com/user_avatar/forumautomation.com/ashlin/32/3775_2.png) [@ashlin](https://forumautomation.com/u/ashlin)\
**Post date:** [September 21, 2021, 4:01am UTC](https://forumautomation.com/t/is-it-possible-to-temporarily-jump-out-a-sensor-by-forcing-an-output-in-the-plc/9868/2 "2021-09-21T04:01:28Z")

</div>

It’s better to use software force than hardwire, in the software, we can add additional information at HMI/Scada that this sensor is in force on/off mode, so the user/operator is aware of it. Sow while doing this we must make sure that there is no other inputs/sensors which would be affected by the final output
