# I am facing a problem with encoder adjustment in Sew Electric Cylinder CMS71L.

**URL:** <https://forumautomation.com/t/i-am-facing-a-problem-with-encoder-adjustment-in-sew-electric-cylinder-cms71l/11851>\
**Category:** Uncategorized\
**Created:** [March 7, 2024, 1:29pm UTC](https://forumautomation.com/t/i-am-facing-a-problem-with-encoder-adjustment-in-sew-electric-cylinder-cms71l/11851 "2024-03-07T13:29:24Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![Suhail](https://forumautomation.com/letter_avatar_proxy/v4/letter/s/b5a626/32.png) [@Suhail](https://forumautomation.com/u/Suhail)\
**Post date:** [March 7, 2024, 1:29pm UTC](https://forumautomation.com/t/i-am-facing-a-problem-with-encoder-adjustment-in-sew-electric-cylinder-cms71l/11851/1 "2024-03-07T13:29:25Z")

</div>

Hi Friends,

I am facing a problem with encoder adjustment in Sew Electric Cylinder CMS71L.

encoder using is Sick Hiperface

Drive is MOVIDRIVE B (MDX61B)

I have tried the procedure as follows.

-after releasing brake i applied 10V DC in V and W terminal (-ve in V, +ve in W) then hold the brake and fitted encoder. -then i have connected to MOVIDRIVE B. and before running i connected drive to movitool for encoder adjustment.

problem 1 -But there are error showing while encoder adjustment and couldn’t finish encoder adjustment.

and after many trying in hardware adjustment, once encoder adjustment finished successfully .

problem2 -But while running motor again it showed encoder error after sometime.

i hop you understand the issue and i am looking for positive response

thank you
