# How to set current to 20mA?

**URL:** <https://forumautomation.com/t/how-to-set-current-to-20ma/646>\
**Category:** Field Instrumentation\
**Created:** [December 4, 2015, 7:12pm UTC](https://forumautomation.com/t/how-to-set-current-to-20ma/646 "2015-12-04T19:12:13Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Joe](https://forumautomation.com/letter_avatar_proxy/v4/letter/j/b9e5f3/32.png) [@Joe](https://forumautomation.com/u/Joe)\
**Post date:** [December 4, 2015, 7:12pm UTC](https://forumautomation.com/t/how-to-set-current-to-20ma/646/1 "2015-12-04T19:12:13Z")

</div>

I haven’t used a 4-20mA sensor since college (+10 years ago) but I would like to use one for my next project. I wish to input analog data from a 4-20mA hydraulic pressure sensor into my controller.

My controller will accept the 1-5V range I expect after sampling across the 250 ohm resistor. What I don’t remember how to do is set the current TO THE SENSOR at 20mA. Do I require a signal conditioner or power supply with exactly 20mA? If so I would appreciate any recommendation on small/cheap devices.

Thank you for any reply, I suspect this will be an easy question for most of the professionals on this site.

Best regards,

Joe

---

<div class="post-metadata">

**Author:** ![denizen](https://forumautomation.com/letter_avatar_proxy/v4/letter/d/848f3c/32.png) [@denizen](https://forumautomation.com/u/denizen)\
**Post date:** [December 5, 2015, 4:09am UTC](https://forumautomation.com/t/how-to-set-current-to-20ma/646/2 "2015-12-05T04:09:08Z")

</div>

Try this …

Circuit diagram 4-20 ma to 1-5 v conversion \<img src=“[//forum-automation-uploads.sfo3.digitaloceanspaces.com/original/1X/3827af73f1f9100c5dc695ae9c9caa80182fcfb2.jpg](https://cdn.forumautomation.com/original/1X/3827af73f1f9100c5dc695ae9c9caa80182fcfb2.jpg)” width=“680” height=“485” alt="4-20 ma to 1-5 conversion '\>
