# How schematic symbols for control valves is derived?

**URL:** <https://forumautomation.com/t/how-schematic-symbols-for-control-valves-is-derived/4782>\
**Category:** Field Instrumentation\
**Created:** [September 28, 2018, 12:42pm UTC](https://forumautomation.com/t/how-schematic-symbols-for-control-valves-is-derived/4782 "2018-09-28T12:42:22Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![rajeena](https://forumautomation.com/letter_avatar_proxy/v4/letter/r/4af34b/32.png) [@rajeena](https://forumautomation.com/u/rajeena)\
**Post date:** [September 28, 2018, 12:42pm UTC](https://forumautomation.com/t/how-schematic-symbols-for-control-valves-is-derived/4782/1 "2018-09-28T12:42:23Z")

</div>

# How schematic symbols for control valves is derived?

### Let’s consider a 3 position 4 port valve.

Control valves are represented using square boxes. Each square boxes represent positions. the number of boxes in the figure specifies the number of operating positions, for example, 3 boxes represent 3 positions.

 ![image](https://cdn.forumautomation.com/original/2X/d/d4a0626050bc6d39cf0cc7331d0edc7d36908ded.jpg)

Pipeworks are normally represented in connection with the box which represents unoperated conditions. As shown in the above figure the position 2 is in unoperated condition. Hydraulic circuits are normally operated in unoperated condition.

 ![image](https://cdn.forumautomation.com/original/2X/5/5d8654725f2aaa325c5e4a09e62f70c3b4b5174d.jpg)

In the above figure, all positions have 4 ports each. The position 2 has all ports blocked. the arrow marks in the position1 and position 3 show the direction of flow. So this is 3 position 4 port valve. this is how the name of the control valve is derived.

## How this valve operate?

 ![image](https://cdn.forumautomation.com/original/2X/f/fb6cbe135b9823783d0c0c168c1c576e01480c32.jpg)

There is no flow at the current position that means at the position 2 all ports are in blocked condition as shown in the figure below. Thus it is getting pressurized.

## When the position 1 aligns with the pipe

When the position 1 aligns with the pipe as in the figure below, the flow is happening in both directions since the pipe is connected.

 ![image](https://cdn.forumautomation.com/original/2X/d/d7c203c6bf568b9e2a03b0adfd9d31f1766ff00a.jpg)

## When position 3 aligns with the pipe

When position 3 aligns with the pipe will be as shown in the figure below. the flow is getting reversed. That’s how it works.

 ![image](https://cdn.forumautomation.com/original/2X/c/cb45475f85fe284c2a2936d6cdeb521ccce81931.jpg)
