# GATE - 2022 Electrical Important Questions with Solutions

**URL:** <https://forumautomation.com/t/gate-2022-electrical-important-questions-with-solutions/12315>\
**Category:** Electrical\
**Tags:** gate\
**Created:** [July 23, 2024, 1:04pm UTC](https://forumautomation.com/t/gate-2022-electrical-important-questions-with-solutions/12315 "2024-07-23T13:04:26Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![Rabert](https://forumautomation.com/user_avatar/forumautomation.com/rabert/32/6784_2.png) [@Rabert](https://forumautomation.com/u/Rabert)\
**Post date:** [July 23, 2024, 1:04pm UTC](https://forumautomation.com/t/gate-2022-electrical-important-questions-with-solutions/12315/1 "2024-07-23T13:04:26Z")

</div>

![image](https://cdn.forumautomation.com/original/2X/2/29e072851836fdb9a21d116426c32d25b07c91e3.jpeg)

**1). The transfer function of a real system, H(s), is given as:**

H(s) = As + B/(s2 + Cs + D) **, where A, B, Cand D are positive constants. This system cannot operate as**

 

(a) low pass filter (b) high pass filter (c) band pass filter (d) an integrator

 

**Answer: (b)**

 

**Solution:**

 

With one zero and two poles, the given system cannot be a high pass filter.

 

**2). For an ideal MOSFET biased in saturation, the magnitude of the small signal current gainfor a common drain amplifier is**

 

(a) 0 (b) 1 (c) 100 (d) infinite

 

**Answer: (d)**

 

**3). The most commonly used relay, for the protection of an alternator against loss of excitation,is**

 

(a) offset Mho relay (b) over current relay (c) differential relay (d) Buchholz relay

 

**Answer: (a)**

 

**Solution:**

 

Off-set Mho relay protects the generator against loss of excitation

 

**4). The valid positive, negative and zero sequence impedances (in p.u.), respectively, for a 220kV, fully transposed three-phase transmission line, from the given choices are**

 

(a) 1.1, 0.15 and 0.08 (b) 0.15, 0.15 and 0.35(c) 0.2, 0.2 and 0.2 (d) 0.1, 0.3 and 0.1

 

**Answer: (b)**

 

**Solution:**

 

For transmission line,

 

X1 = X2 \< X0

 

X0 = 2.5 to 3 times of X1

 

**5). A charger supplies 100 W at 20 V for charging the battery of a laptop. The power devices,used in the converter inside the charger, operate at a switching frequency of 200 kHz. Whichpower device is best suited for this purpose?**

 

(a) IGBT (b) Thyristor (c) MOSFET (d) BJT

 

**Answer: (c)**

 

**Solution:**

 

For higher switching frequencies like 200 kHz, power MOSFET is best suitable.

 

**6). The type of single-phase induction motor, expected to have the maximum power factorduring steady state running condition, is**

 

(a) split phase (resistance start) (b) shaded pole(c) capacitor start (d) capacitor start, capacitor run

 

**Answer: (d)**

 

**Solution:**

 

Having a run capacitor [permanent capacitor] can improve the power factor of induction motor

 

**7). A MOD 2 and a MOD 5 up-counter when cascaded together resuls in a MOD \_\_\_\_\_ counter.(in integer)**

 

**Answer: (10)**

 

**Solution:**

 

Modulus of a cascaded counter of Mod-M and Mod-N is MN

 

Hence, modulus of a cascade of Mod-2 and Mod-5 counter = 5 X 2 = 10

 

**8). The frequencies of the stator and rotor currents flowing in a three-phase 8-pole inductionmotor are 40 Hz and 1 Hz, respectively. The motor speed, in rpm, is \_\_\_\_\_ (round off tonearest integer)**

 

**Answer: (585)**

 

**Solution:**

 

Given f1 = 40 Hz

 

f2 = 1 Hz

 

we know f 2 = sf1

 

S = 1/40

 

Rotor speed

 

Nr = (1 – S) N

 

Nr = (1-1/4) (120 x 40/8) = 585 rpm

 

**9).**  **A 3-phase, 415 V** \*\*, 4-pole, 50 Hz\*\* **induction motor draws**  **5 times the rated current at** **rated\*\*\*\*voltage at starting. It is required to bring down the starting current from the supply to 2times of the rated current using a 3-phase autotransformer. If the magnetizing impedanceof the induction motor and no-load current of the autotransformer is neglected, then thetransformation ratio of the autotransformer is given by \_\_\_\_\_\_\_ (round off to two decimalplaces).**

 

**Answer: (0.6324)**

 

**Solution:**

 

Given Isc = 5 IFL

 

When auto-transformer starter is used,

 

Istart = x² Isc

 

2IFL = x2 [5FL]

 

x = 0.6324

 

**10). Consider a 3** x **3 matrix A whose (i, j)-th element, a** **i,j = (i – j)**  **3****. Then the matrix A will be**

 

(a) symmetric (b) skew-symmetric (c) unitary (d) null

 

**Answer: (b)**
